Difference between revisions of "PublicHome/Hardware/ECU/Gen3Firmware Freightliner"
< PublicHome | Hardware | ECU
(Created page with "<strong>SpartanLync ECU GEN 1 Freightliner Firmware Information</strong> == ECU Firmware Introduction == right|frameless The SpartanLync GEN 3 E...") |
|||
| Line 1: | Line 1: | ||
| − | <strong>SpartanLync ECU GEN | + | <strong>SpartanLync ECU GEN 3 Freightliner Firmware Information</strong> |
== ECU Firmware Introduction == | == ECU Firmware Introduction == | ||
Revision as of 13:07, 7 June 2022
SpartanLync ECU GEN 3 Freightliner Firmware Information
Contents
ECU Firmware Introduction
The SpartanLync GEN 3 ECU for Freightliner is the central electronic control unit for communication with SpartanLync TPMS sensors in a vehicle.
This page allows Freightliner service agents to perform a software update to the controlling firmware in these ECU devices.
Note: This ECU Firmware does not support SpartanLync TempTrac sensors
Freightliner ECU Flashing Requirements
The SpartanLync ECU Firmware Flashing requires the following
- Freightliner-specific ECU installations
- Windows Computer hardware-installed with a NexiQ USB-Link 2 adapter
- 9-pin Deutsch Adapter cable (Standard 1 meter cable for use with USB-Link 2)
- Spartanlync flash cable (Part number 110310000440)
Freightliner ECU Firmware Update Requirements
You should only update the ECU if it meets the following requirements
- Part number: 110302080465
- SW version: V 5.2
- Time Range: Before Jan of 2021
Freightliner ECU Firmware Update Download
- Download latest Firmware and the Windows Flash Utility (Installation and Flashing instructions included)
