Difference between revisions of "PublicHome/Hardware/ECU/Gen3Firmware Freightliner"

Latest revision as of 19:01, 20 June 2022

SpartanLync ECU GEN 3 Freightliner Firmware Information

The SpartanLync GEN 3 ECU for Freightliner is the central electronic control unit for communication with SpartanLync TPMS sensors in a vehicle.

This page allows Freightliner service agents to perform a software update to the controlling firmware in these ECU devices.

Note: This ECU Firmware does not support SpartanLync TempTrac sensors

The SpartanLync ECU Firmware Flashing requires the following

Windows Computer / Laptop USB connected to a NexiQ 2 adapter
9-pin Deutsch Adapter cable (Standard 1 meter cable for use with USB-Link 2) plugged into Vehicle CAN
Spartanlync ECU plugged into the same Vehicle CAN as NexiQ 2 adapter
Vehicle turned on

You should only update the ECU if it meets the following requirements

Download latest Firmware and the Windows Flash Utility (Installation and Flashing instructions included)

@@ Line 6: / Line 6: @@
 <p>Note: '''This ECU Firmware does not support SpartanLync TempTrac sensors'''
-<!--
 == Freightliner ECU Flashing Requirements ==
 The SpartanLync ECU Firmware Flashing requires the following
-* Freightliner-specific ECU installations
+* Windows Computer / Laptop USB connected to a NexiQ 2 adapter
-* Windows Computer hardware-installed with a NexiQ USB-Link 2 adapter
+* 9-pin Deutsch Adapter cable (Standard 1 meter cable for use with USB-Link 2) plugged into Vehicle CAN
-* 9-pin Deutsch Adapter cable (Standard 1 meter cable for use with USB-Link 2)
+* Spartanlync ECU plugged into the same Vehicle CAN as NexiQ 2 adapter
-* Spartanlync flash cable (Part number 110310000440)
+* Vehicle turned on
-[[File:NexiQ USB-Link 2 adapter.jpg|frameless|600x190px]]
--->
 == Freightliner ECU Firmware Update Requirements ==